Automatic Transmissions & Transaxles

The function of an accumulator is to.

Under ideal conditions, automatic transmission fluid operating temperature should be about.

The first step in removing a transmission is always to.

Selective servo pin band adjustments are usually performed.

As a general rule, the coefficient of friction for a lockup torque converter clutch friction material should be.

Rotating the torque converter counterclockwise while holding the pump is a test of the.

A torque converter defect can cause all of the following symptoms EXCEPT.

The resistance of an NTC thermistor.

Which of the following items is not needed when performing a comprehensive road test?

When flushing a transmission cooler with compressed air, air pressure should be kept below.

Which of the following sensors is used to measure changes in temperature?

Which of the following measurements does NOT apply to a gear-type oil pump?

A friction material coefficient test is used to measure the holding effectiveness of a:

Email My Results To

*Not Required

Automatic Transmissions & Transaxles Assessment